This cute and stunning earring is made up of White color paper and Black round-cut clear cubic zirconia stones. This jhumka is light-weight and perfectly matching to those who love to be different.
Supplies needed:
- Earring posts and ear backs – 1 pair
- Eye pins – 1 pair
- Paper Strips (desired colors )
- Black round-cut clear cubic zirconia stones chain
- 4mm daisy Spacer Beads – 2 nos.
- 4mm flower shaped Spacer Beads – 2 nos.
- Gold plated flat cable chain – 2 inch piece
- Craft glue
Tools Needed:
- Wire Cutter
- Round Nose Pliers
- Flat Nose Pliers
- Quilling needle or tool
METHOD:
Step 1:
Insert 2 paper strips together in a slotted needle.
Step 2:
Keep quilling to make a tight coil. Glue the end so that the coil is secure. Now your ear stud base is ready.
Step 3:
Apply a coat of fabric glue on both sides of the ear stud base. Allow it to dry.
Step 4:
Then insert a paper quilling strip in a slotted needle. Keep quilling till you make a tight coil of the desired size . You have to glue together the paper strips ends before quilling the coil so that the coil is secure.
Step 5:
Once done, glue the end of the paper and let it dry.
Step 6:
Slide and remove the coil from the slotted tool, Then gently push the center end of the rolled paper upwards in such a way that it brings out a conical shape. Now with the help of the needle tool and your fingers, set the shape (cup shape ) properly. Make sure there is some room in the cone's tip, to insert the eye-pin.
Step 7:
Apply a small amount of fabric glue on the inside of the cup shape and the outside. Allow it to dry. The structure will be secure now.
Step 8:
You can apply clear color nail polish in the cup shape and ear stud base, that will give a glossy shine.
Step 9:
Now place one 4mm flower shaped Spacer Bead on top of the cup or cone shaped paper Jhumka base and insert the eye-pin on the center of the flower shaped Spacer Bead to the narrow hole of the Jhumka, in such a way that the `eye' sits inside of the cone, and bend the pin's other end from the top of the cone to steady it.
Step 10 :
Using round nose pliers make a loop at the top. Use wire cutters to trim off any excess wire after making the loop. Before you close the loop, you can insert a small piece of Gold plated flat cable chain in the loop then close the loop well.
Step 11:
Apply some glue at the end of the cup shape and arrange Black round-cut clear cubic zirconia stones there. Your Jhumka is ready. Keep it aside.
Step 12:
Take the paper stud base and Glue a 4mm daisy Spacer Bead on a at the center of the small coil and glue a Black round-cut clear cubic zirconia stone at the center of the daisy spacer bead. Now your ear stud is ready.
Step 13:
Then apply glue on an earring post and attach the small coil’s back end to the earring post. It has to hold on well… allow it to dry completely.
Step 14:
Now insert the other end of Gold plated flat cable chain (one end is attached with the cup shaped paper Jhumka ) in the ear stud post. Advantage of this method of Jhumka making is, you can wear stud alone if you wish or both the stud and hangings together as traditional Jhumkis. (Separating and joining together the ear stud and hanging is easy according to your occasions and dresses).
Step 15:
Repeat steps above for the other earrings piece and make your pair of quilling jhumka earrings.
Comments